Global Polytec Ltd.,Part.

Question by Carlos M: custom 1948 chevy fuel injection system (98 yukon drivetrain)?
how to make the fuel injection work?, can i just plug,or vent the egr to the throttle body.? can i use a plastic fuelcell,with an inline fuel pump,?
im preatty auto savy but i lack a little in some fields. i have the complete wiring harness,with copmuter for the trans and engine. i have it all together now in the car evrything is pluged were it needs to be pluged. minus the ignition switch i wanna wire it diffrent in the dash were it belongs i want the car to look almost original but not quiet im using my stock steering column. so all of my concerns are the fuel pump, lines, gas tank the gas tank on the yukon was garbage so i need an [in line fuel injection fuel pump] ive seen them on ebay but im unsure what pressure rating to get, and i need to know if i can use a plastic gas tank with a [vented fuelcap] to run my fuel injection. and if i can use fuel injection rubber hose and clamps at some ends to save time and bending. and this truck had the EGR hose from the manifold going to the exhaust can i just plug it or put it on my throttle body. i dont want the car to run bad any advise u have is appreciated thanx

Best answer:

Answer by shaggy1353
you will need the entire wiring harness, or you can buy a harness but I’m not sure that they make one other than for a early model injected chevy…you will need the ecm,and any trans wiring and ecm’s that are drive train related…this will be a good project, check out painless wiring…if anyone has this wiring harness … they do..other than that get friendly with the guy at the salvage yard ……who can save you lots of money and time looking for ods and ends…so you have a lot of work ahead other than what u asked in your question

Add your own answer in the comments!

Comments are closed.