Posts Tagged ‘motor’

Linear motor: Regulated injection with up to 2000 mm/sec

– www.arburg.com – Extremely high acceleration speed of 8 g Linearmotor Geregeltes Einspritzen mit bis zu 2000 mm/s – www.arburg.com – Extrem hohes Beschleunigungsvermögen von 8 g

92 festiva oil coming up on motor and oil in the plastic going from the breather to the fuel injection port?

Question by hacker: 92 festiva oil coming up on motor and oil in the plastic going from the breather to the fuel injection port?
I had a new timing belt put on prior to this but has never had any power since. I had the engine totally overhauled about a year ago and it ran fine but since I replaced the timingbelt it hasn’t ran right sence. there is no power at all. I replaced the PCV valve but still get oil back in the breather area from breather to fuel injector.The engine shuts off real fast like its to tight and there is oil that drips on the floor, uses about a half quart every 30 or 40 miles.There is blue smoke that comes out periodically but not all the time.There is a small water leak on the floor, could this be from the water pump leaking on the timing belt ,and cause the timing belt to jump time.Sometime it is hard to start when you turn it off so I let run to get back home. Have put new plugs and coil wire in it. What could be my problem. THANKS

Best answer:

Answer by Jcontrols
Do a compression check.Sounds like excessive blow-by in one of the cylinders,,;-(=

Know better? Leave your own answer in the comments!